Heavy smoke after sitting at idle
This has happened twice now. Normally I only let the engine warm up for a minute with the trans in neutral before driving away. I do not let it sit there running in the drive way for 15 min. But twice...
View ArticleWIX fuel filter
Anyone have and problems with WIX fuel filters. They say they are a 2 micron nominal so I assume they are ok to use.
View ArticleAdrenaline pv2!!! Trade ?
I posted this awhile back and ended up updating it and liked it more and kept it and bought the fuel psi sensor for it and windshield mount but Iam now still wanting to trade it for a blue chip fms or...
View ArticleEFILive In Action!
Hey, Guys. Check out this EFI tuned truck haulin' at the track: http://www.cumminsforum.com/forum/ad...ay-thanks.html Good run man! :party018:
View ArticleCenter Console creeks and squeaks...
Anyone else suffering from them? Seems whenever i get on a crappy road.... Theres alot here in SATX that it makes a rachet. I cant seem to find the root cause since im driving obviously. Anyone have...
View ArticleInjector install questions
So after a month of on/off code P2149 (injector bank B short) It finally is permanently running on 3 cylinders. Without taking it apart yet, I believe injector #6 is the culprit due to a quick Ohm test...
View ArticleSeeking Local Cummins Experts / Shops
All, I'm seeking input from local Cummins experts/shops regarding the Dodge in my sig. The truck (to me) feels like a slug. The truck has some mods geared toward towability. Mods are as follows:...
View ArticleWTB HX and Hy turbos
ooking for cheap/used/need rebuilt hx35's hy35's if needed rebuilt thats totally fine, cheaper the better
View Articleecu???
had to put a new immobilizer in and now the computer wont let it be programmed. is the ecu fried? anyone know where to get a new one besides the stealership? stuck in a waiting room and want to get...
View ArticleSpreading the word! $50 hot unlock at Edge for Cyber Monday
Hey guys, just spreadin the word that Edge is doing hot unlock codes on cyber monday for $50! Hope I'm not breaking any rules by posting this. Just tryin to help anyone out who was thinkin about...
View ArticleNeed help quick. Not at home.
I have the FRRP it was running 18 psi on the way to campground towing my 5th wheel with the edge on tow. I have my alarm at 9 psi. About 3/4 the way to the camp ground the alarm sounded. 9 psi the 10...
View ArticlePuller Part Out
Black Crew Cab Long Bed Complete Chassis-12000 Front elocker with gears 800 Water to air intercooler dual core with 4 inch inlets 1200 Kennys weighted triple 2000 Nv4500 with 1 3/8 input 1500 Stock NV...
View ArticleWTB clutch pedals for my eaton fuller swap
looking to buy clutch and brake pedals for my eaton fuller swap. i have a 92 w350 with an auto currently, thanks!
View Articlewindshield washer just dribbles out
Now that its getting winter I need my windshield washers. It seems to only dribble out of the drivers side and almost unnoticeable on the passenger side. Fluid is full. I do not see anything obvious....
View ArticleAggressive stance
Hey guys I just bought another cummins. I have a few ideas on the wheel and tire setup I want to get, but I'd like to see some pics of what you guys are running. I'd like to see some stock height, or...
View ArticleTransmission and Transfer case Service ??
I am about to service the trans. , and transfer case with full fluid replacement including , filter , front and rear band adjustment , new BW gov. sol. and sensor , . I was just curious as to everyones...
View Articlecan an 1 tell me if i want the go to the 22.5 semi rims if i will have to put...
i can anyone tell me if i have to put on a lift to add the semi rims and tires, i have the 3/4 ton , with a front leveling kit on, it sets high know. i have 315 70 17 on it know and it doesnt hit...
View ArticleWhats up with this?
My volts gauge bounces back and forth until you hit the throttle, then it stops. Could it be a bad voltage regulator, I just had to replace that last year. It has done it as long as I can remember, and...
View ArticleRe calibrate after installing timbo APPS
Well, like the title says, do I need to do a recalibration after installing this? After I installed this an if I smash it I can't get much more than about 25-28psi, unless I let up, jockey the pedal a...
View Article
