Ok guys... I just got my ScangaugeII the other day, and I literally spent hours sitting in my truck debating on the best place to put it. I wanted a place that was in sight, and of course, I wanted a clean install. I spent some time searching online to see where other second gen owners had them and couldn't come up with too much. So basically, here is where I decided to mount mine...
![]()
I actually took an old license plate, hammered it flat (takes some finesse to get it nice and flat. Honestly, this part isn't that important... I'm just a little OCD.) I cut about an inch off the top and bottom. I then bent one end to an angle in order to mount the gauge to. Drilled a 1/2" hole for the connector. I then slid it underneath the headliner and attached the gauge with velcro. The pressure holds everything nicely with no need to drill holes anywhere. Here is a picture of the back side of the ScangaugeII to give you an idea. (There are two 1/2" holes in mine... I drilled the first on the wrong side :doh:):
![]()
So lets see where you guys have mounted them!!!
I actually took an old license plate, hammered it flat (takes some finesse to get it nice and flat. Honestly, this part isn't that important... I'm just a little OCD.) I cut about an inch off the top and bottom. I then bent one end to an angle in order to mount the gauge to. Drilled a 1/2" hole for the connector. I then slid it underneath the headliner and attached the gauge with velcro. The pressure holds everything nicely with no need to drill holes anywhere. Here is a picture of the back side of the ScangaugeII to give you an idea. (There are two 1/2" holes in mine... I drilled the first on the wrong side :doh:):
So lets see where you guys have mounted them!!!