So Ive developed a strange wobble in my steering. Its almost like 4wd is enguaged when Im turning corners, its a bit of a kick back when turning at slow speeds. I think its my front U Joints going out (I think its just the driver side) so Ive been thinking of replacing both just to get them done. My quess is they are still the stock ones (164K on the truck).....
My question is, how hard is it to auctually change them out? I dont have a torch to cut them out, or a press to press them out. I HATE paying someone else to do things that I am capable of doing myself, but Ive never auctually had a truck long enough to have to replace U Joints in the axle, so Ive never done this before, but I dont see what I cant........
So does any one have any tips, tricks or advice before I start tearing things down???? Just want to get all my bases covered before I start.
Alxo any reccomendations or part numbers for the best U Joint?
My question is, how hard is it to auctually change them out? I dont have a torch to cut them out, or a press to press them out. I HATE paying someone else to do things that I am capable of doing myself, but Ive never auctually had a truck long enough to have to replace U Joints in the axle, so Ive never done this before, but I dont see what I cant........
So does any one have any tips, tricks or advice before I start tearing things down???? Just want to get all my bases covered before I start.
Alxo any reccomendations or part numbers for the best U Joint?